Installation - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
3.3.2

Installation

To install a PZ-VM21 on the CD-CP00:
Do not remove or install the CD-CP00 with the
power on.
1. Included with the PZ-VM21 are four plastic spacers. Install the
plastic spacers onto the PZ-VM21. Make sure to attach the
spacers so that they extend out on the side of the daughter
board which has the CN1 connector. Refer to
Installing the PZ-VM21 on page
2. For installation on the CD-CP00 blade refer to
CD-CP00 Blade with Daughter Boards Installed on page
3. Position the PZ-VM21 CN1 connector over the CN4 connector
on the CD-CP00
the plastic spacers lock in place.
4. Insert the CompactFlash card into the CN2 slot.
The LED1 status lights steadily when a card is installed.
.
4-32.
. Press the boards together, ensuring
blade
Issue 7.0
Figure 4-8
Figure 4-4
4-17.
4 - 31