NEC UNIVERGE SV8100 System Hardware Manual page 392

Issue 7.0
Top LED, Yellow
5 - 120
2. Route the cable through the channel.
Figure 5-148 Install AP300 Base Station
3. Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the
front briefly lights yellow and then turns off while it initializes
and connects to the network. After the base station
successfully initializes and connects to the network, the Yellow
LED light remains steady on (refer to
LED States and Meanings on page
Table 5-14 Base Station LED States and Meanings
LED Status
Off
0.5 seconds on - 0.5
seconds off
Short flash every
0.25 seconds
Fast Blink
Continuous Fast
Blink
Steady On
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
State
No Power
Loading software/firmware
IP Network error (not connected, no DHCP/
TFTP server, no DAP Controller
DAP Operational but trying to synchronise to
another DAP
Hardware Error
DAP Operational (and synchronised to other
DAP or is the synchronisation master)
UNIVERGE SV8100
Table 5-14 Base Station
5-120).
Meaning