Displaying And Maintaining Mce; Mce Configuration Examples; Configuring The Mce That Uses Ospf To Advertise Vpn Routes To The Pe - HP FlexNetwork 10500 Series Configuration Manual

Configuring IBGP between an MCE and a PE
Step
1. Enter system view.
2. Enter BGP instance view.
3. Enter BGP-VPN instance
view.
4. Configure the PE as an IBGP
peer.
5. Enter BGP-VPN IPv4 unicast
address family view.
6. Enable BGP to exchange
IPv4 unicast routes with the
peer.
7. Redistribute the VPN routes
of the VPN site.

Displaying and maintaining MCE

Execute display commands in any view.
Task
Display VPN instance information.
For commands that display routing tables for VPN instances, see Layer 3—IP Routing Command
Reference.

MCE configuration examples

Configuring the MCE that uses OSPF to advertise VPN
routes to the PE
Network requirements
As shown in
different VPNs and to advertise the VPN routes to PE 1 through OSPF.
Command
system-view
bgp as-number [ instance
instance-name ]
[ multi-session-thread ]
ip vpn-instance vpn-instance-name
peer { group-name | ipv4-address
[ mask-length ] } as-number
as-number
address-family ipv4 [ unicast ]
peer { group-name | ipv4-address
[ mask-length ] } enable
import-route protocol [ process-id |
all-processes ] [ allow-direct | med
med-value | route-policy
route-policy-name ] *
Figure 112, VPN 2 runs OSPF. Configure the MCE device to separate routes from
Command
display ip vpn-instance [ instance-name vpn-instance-name ]
434
Remarks
N/A
By default, BGP is not
enabled.
N/A
By default, no BGP peers or
peer groups exist.
N/A
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
By default, no routes are
redistributed into BGP.