Configuring An Mpls Te Tunnel To Use A Crlsp Calculated By Pces; Configuring A Pce; Discovering Pces - HP FlexNetwork 10500 Series Configuration Manual

Step
4. Set the retry interval.
Configuring RSVP resource reservation style
Step
1. Enter system view.
2. Enter MPLS TE tunnel
interface view.
3. Configure the resources
reservation style for the
tunnel.
Configuring an MPLS TE tunnel to use a CRLSP
calculated by PCEs

Configuring a PCE

Step
1. Enter system view.
2. Enter MPLS TE view.
3. Configure a PCE IP address.

Discovering PCEs

After the PCE is manually specified or dynamically discovered, a PCC sends a PCEP connection
request to the PCE, but it does not accept a request from the PCE.
Manually specifying a PCE
Step
1. Enter system view.
2. Enter MPLS TE view.
3. Specify the IP address of the PCE.
Dynamically discovering PCEs
OSPF TE advertises PCE IP addresses for PCCs and other PCEs to dynamically discover the PCEs
and establish PCEP sessions to them. For OSPF TE configuration, see
Command
mpls te timer retry seconds
Command
system-view
interface tunnel tunnel-number
[ mode mpls-te ]
mpls te resv-style { ff | se }
Command
system-view
mpls te
pce address ip-address
Command
system-view
mpls te
pce static ip-address
93
Remarks
By default, the retry interval is 2
seconds.
Remarks
N/A
N/A
By default, the resource reservation
style is SE.
In current MPLS TE applications,
tunnels are established usually by
using the make-before-break
mechanism. As a best practice, use
the SE style.
Remarks
N/A
N/A
By default, no PCE address is
configured.
Remarks
N/A
N/A
By default, no PCE peers exist.
"Configuring OSPF TE."