Configuring Routing On An Mce - HP FlexNetwork 10500 Series Configuration Manual

Step
2. Enter VPN instance
view or VPN instance
IPv4 VPN view
3. Configure route targets.
4. Set the maximum
number of active routes.
5. Apply an import routing
policy.
6. Apply an export routing
policy.
7. Apply a tunnel policy to
the VPN instance.

Configuring routing on an MCE

MCE implements service isolation through route isolation. MCE routing configuration includes the
following:
•
MCE-VPN site routing configuration.
•
MCE-PE routing configuration.
On the PE, perform the following tasks:
•
Disable routing loop detection to avoid route loss during route calculation.
Command
•
Enter VPN instance view:
ip vpn-instance
vpn-instance-name
•
Enter VPN instance IPv4 VPN
view:
a. ip vpn-instance
vpn-instance-name
b. address-family ipv4
vpn-target vpn-target&<1-8> [ both |
export-extcommunity |
import-extcommunity ]
routing-table limit number
{ warn-threshold | simply-alert }
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
426
Remarks
Configurations made in VPN
instance view apply to both IPv4
VPN and IPv6 VPN.
IPv4 VPN prefers the
configurations in VPN instance
IPv4 VPN view over the
configurations in VPN instance
view.
By default, no route targets are
configured.
By default, the number of active
routes is not limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from learning
too many routes.
By default, all routes matching the
import target attribute are
accepted.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing) in
this order: LSP tunnel, GRE
tunnel, and CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "Configuring tunnel
policies."