HP FlexNetwork 10500 Series Configuration Manual page 138

# On switch D, create a static route to direct traffic destined for 100.1.1.0/24 to MPLS TE tunnel
4.
[SwitchD] ip route-static 100.1.1.0 24 tunnel 4 preference 1
Verifying the configuration
# Verify that the tunnel interface is up on Switch A.
[SwitchA] display interface tunnel
Tunnel1
Current state: UP
Line protocol state: UP
Description: Tunnel1 Interface
Bandwidth: 64kbps
Maximum transmission unit: 1496
Internet address: 7.1.1.1/24 (primary)
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel on Switch A.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: Disabled
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
: Tunnel 1
: Up (Main CRLSP up, Reverse CRLSP up)
:
: 30478 Tunnel ID
: Normal
: 1.1.1.9 Egress LSR ID
: RSVP-TE Static CRLSP Name
: FF
: Co-routed, active
: -
: - Reverse-LSP Tunnel ID: -
: CT0 Tunnel Bandwidth
: 0 kbps
: 7 Holding Priority
: 0/0
: -
: TE
: Disabled Record Label
: Disabled Bandwidth Protection : Disabled
Backup Bandwidth Type: -
: -
: No Auto Created
: Disabled
: 10 Retry Interval
: Disabled Reoptimization Freq
129
: 1
: 4.4.4.9
: -
: 0 kbps
: 7
: Disabled
: No
: 2 sec
: -