HP FlexNetwork 10500 Series Configuration Manual page 449

Figure 113 Network diagram
VPN 1
172.16.10.0
Configuration procedure
1. Create VPN instances on the MCE and PE 1, and bind the VPN instances to VLAN interfaces.
For the configuration procedure, see
routes to the
2. Configure routing between the MCE and VPN sites:
# Enable an OSPF process on the devices in the two VPNs, and advertise the subnets. (Details
not shown.)
# Configure OSPF on the MCE, and bind OSPF process 10 to VPN instance vpn1 to learn the
routes of VPN 1.
<MCE> system-view
[MCE] ospf 10 router-id 10.10.10.1 vpn-instance vpn1
[MCE-ospf-10] area 0
[MCE-ospf-10-area-0.0.0.0] network 10.214.10.0 0.0.0.255
[MCE-ospf-10-area-0.0.0.0] quit
[MCE-ospf-10] quit
# Display the routing table of VPN 1 on the MCE.
[MCE] display ip routing-table vpn-instance vpn1
Destinations : 13
Destination/Mask
0.0.0.0/32
10.214.10.0/24
10.214.10.0/32
Vlan-int30: 30.1.1.2/24
Vlan-int40: 40.1.1.2/24
MCE
Vlan-int2
10.100.10.1/24
VR 1
VPN 2
172.16.20.0
PE."
Routes : 13
Proto
Direct
Direct
Direct
PE 1
Vlan-int30: 30.1.1.1/24
Vlan-int40: 40.1.1.1/24
Vlan-int3
10.100.20.1/24
VR 2
"Configuring the MCE that uses OSPF to advertise VPN
Pre Cost NextHop
0 0 127.0.0.1
0 0 10.214.10.3
0 0 10.214.10.3
440
VPN 2
Site 1
CE 1
PE 2
PE 3
CE 2
VPN 1
Site 2
Interface
InLoop0
Vlan10
Vlan10