HP FlexNetwork 10500 Series Configuration Manual page 124

link that the tunnel traverses is 10000 kbps and the maximum reservable bandwidth of the link is
5000 kbps.
Figure 34 Network diagram
IP network
Vlan-int10
Switch A
Loop0
Table 4 Interface and IP address assignment
Device
Switch A
Switch B
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure OSPF to advertise routes within the ASs, and redistribute the direct and BGP routes
into OSPF on Switch B and Switch C:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ospf
[SwitchB-ospf-1] import-route direct
[SwitchB-ospf-1] import-route bgp
[SwitchB-ospf-1] area 0
MPLS backbone
AS 100
Vlan-int1
Loop0
Vlan-int1
Vlan-int2
Switch B
Interface IP address
Loop0 1.1.1.9/32
Vlan-int1 10.1.1.1/24
Vlan-int10 100.1.1.1/24
Loop0 2.2.2.9/32
Vlan-int1 10.1.1.2/24
Vlan-int2 20.1.1.1/24
MPLS backbone
AS 200
Loop0
Vlan-int3
Vlan-int2
Switch C
Device Interface
Switch D Loop0
Vlan-int3
Vlan-int10
Switch C Loop0
Vlan-int3
Vlan-int2
115
IP network
Vlan-int10
Switch D
Vlan-int3
Loop0
IP address
4.4.4.9/32
30.1.1.2/24
100.1.2.1/24
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24