Configuring A Hub-Spoke Network - HP FlexNetwork 10500 Series Configuration Manual

Destination: 2001:3::/96
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
[PE1] display ipv6 routing-table vpn-instance vpn2
Destinations : 6 Routes : 6
Destination: ::1/128
NextHop
Interface
Destination: 2001:2::/96
NextHop
Interface
Destination: 2001:2::2/128
NextHop
Interface
Destination: 2001:4::/96
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
The output shows that PE 1 has routes to the remote CEs. Output on PE 2 is similar.
# Verify that CEs of the same VPN can ping each other, and CEs of different VPNs cannot ping each
other. For example, CE 1 can ping CE 3 (2001:3::1), but cannot ping CE 4 (2001:4::1). (Details not
shown.)

Configuring a hub-spoke network

Network requirements
The Spoke-CEs cannot communicate directly. They can communicate only through the Hub-CE.
: ::FFFF:3.3.3.9
: Vlan13
: ::
: NULL0
: ::
: NULL0
: ::1
: InLoop0
: ::
: Vlan12
: ::1
: InLoop0
: ::FFFF:3.3.3.9
: Vlan13
: ::
: NULL0
: ::
: NULL0
293
Protocol : BGP4+
Preference: 255
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : BGP4+
Preference: 255
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0