HP FlexNetwork 10500 Series Configuration Manual page 419

[PE3] mpls ldp
[PE3-ldp] quit
# Enable L2VPN.
[PE3] l2vpn enable
# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish PWs to PE 1
and PE 2.
[PE3] vsi aaa
[PE3-vsi-aaa] pwsignal ldp
[PE3-vsi-aaa-ldp] peer 1.1.1.9 pw-id 500
[PE3-vsi-aaa-ldp-1.1.1.9-500] quit
[PE3-vsi-aaa-ldp] peer 2.2.2.9 pw-id 500
[PE3-vsi-aaa-ldp-2.2.2.9-500] quit
[PE3-vsi-aaa-ldp] quit
[PE3-vsi-aaa] quit
# Create Ethernet service instance 1000 on GigabitEthernet 1/0/1 (the interface connected to
CE 3), and bind the Ethernet service instance to VSI aaa.
[PE3] interface gigabitethernet 1/0/1
[PE3-GigabitEthernet1/0/1] service-instance 1000
[PE3-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 100
[PE3-GigabitEthernet1/0/1-srv1000] xconnect vsi aaa
[PE3-GigabitEthernet1/0/1-srv1000] quit
[PE3-GigabitEthernet1/0/1] quit
Verifying the configuration
# Verify that PWs in up state have been established on each PE.
[PE1] display l2vpn pw verbose
VSI Name: aaa
Peer: 3.3.3.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
Peer: 2.2.2.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
[PE2] display l2vpn pw verbose
VSI Name: aaa
PW ID: 500
: LDP
: 8 PW State : Up
: 1275 Out Label: 1272
: 1500
: Main
: -
: -
: 0x660000000
: 1032
PW ID: 500
: LDP
: 9 PW State : Up
: 1274 Out Label: 1274
: 1500
: Main
: -
: -
: 0x760000001
: 1033
410