Configuring Ipv6 Mpls L3Vpn Inter-As Option A - HP FlexNetwork 10500 Series Configuration Manual

56 bytes from 12::1, icmp_seq=3 hlim=59 time=1.000 ms
56 bytes from 12::1, icmp_seq=4 hlim=59 time=0.000 ms
--- Ping6 statistics for 12::1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 0.000/0.400/1.000/0.490 ms

Configuring IPv6 MPLS L3VPN inter-AS option A

Network requirements
CE 1 and CE 2 belong to the same VPN. CE 1 accesses the network through PE 1 in AS 100, and
CE 2 accesses the network through PE 2 in AS 200.
Configure IPv6 MPLS L3VPN inter-AS option A, and use the VRF-to-VRF method to manage VPN
routes.
Run OSPF on the MPLS backbone of each AS.
Figure 79 Network diagram
MPLS backbone
AS 100
PE 1
CE 1
AS 65001
Table 25 Interface and IP address assignment
Device
CE 1
PE 1
ASBR-PE 1
Loop0
Vlan-int12
Vlan-int11
ASBR-PE 1
Loop0
Vlan-int11
Vlan-int12
Vlan-int12
Interface IP address
Vlan-int12 2001:1::1/96
Loop0 1.1.1.9/32
Vlan-int12 2001:1::2/96
Vlan-int11 172.1.1.2/24
Loop0 2.2.2.9/32
Vlan-int11 172.1.1.1/24
Vlan-int12 2002:1::1/96
MPLS backbone
Loop0
Vlan-int12
Vlan-int11
ASBR-PE 2
Loop0
Vlan-int11
Vlan-int12
Vlan-int12
AS 65002
Device
CE 2
PE 2
ASBR-PE 2
300
AS 200
PE 2
CE 2
Interface IP address
Vlan-int12 2001:2::1/96
Loop0 4.4.4.9/32
Vlan-int12 2001:2::2/96
Vlan-int11 162.1.1.2/24
Loop0 3.3.3.9/32
Vlan-int11 162.1.1.1/24
Vlan-int12 2002:1::2/96