HP FlexNetwork 10500 Series Configuration Manual page 325

Figure 82 Network diagram
Loop0
CE 1
Vlan-int11
Vlan-int12
Table 28 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
Configuration procedure
1. Configuring basic IPv6 MPLS L3VPN:
Configure OSPF on the MPLS backbone to allow the PEs and P device to learn the routes

of the loopback interfaces from each other.
Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs.

Establish an MP-IBGP peer relationship between the PEs to advertise VPN IPv6 routes.

Configure the VPN instance of VPN 1 on PE 1 to allow CE 1 to access the network.

Configure the VPN instance of VPN 1 on PE 2 to allow CE 2 to access the network.

Configure BGP as the PE-CE routing protocol, and redistribute routes of the CEs into the

PEs.
For more information about basic IPv6 MPLS L3VPN configurations, see
MPLS L3VPNs."
# Execute the display ipv6 routing-table command on CE 2 to verify that CE 2 has not learned
the route to the VPN (100::/96) behind CE 1.
<CE2> display ipv6 routing-table
Destinations : 6 Routes : 6
Vlan-int12
Vlan-int12
Vlan-int11
PE 1
VPN 1
AS 600
Interface IP address
Vlan-int11 10:1::2/96
Vlan-int12 100::1/96
Loop0 10.1.1.1/32
Vlan-int11 10:1::1/96
Vlan-int12 20.1.1.1/24
Vlan-int12 10:2::2/96
Vlan-int13 200::1/96
MPLS backbone
AS 100
Loop0
Vlan-int11
Vlan-int11
P
Device
P
PE 2
316
Loop0
Vlan-int12
PE 2
CE 2
Vlan-int12
VPN 1
AS 600
Vlan-int13
Interface IP address
Loop0 2.2.2.9/32
Vlan-int11 30.1.1.1/24
Vlan-int12 20.1.1.2/24
Loop0 10.1.1.2/32
Vlan-int11 30.1.1.2/96
Vlan-int12 10:2::1/24
"Configuring IPv6