HP FlexNetwork 10500 Series Configuration Manual page 462

Step
3. Set the router ID.
4. Disable routing loop
detection.
5. Redistribute VPN routes.
6. Return to system view.
7. Enter interface view.
8. Enable the OSPFv3 process
on the interface.
Configuring IPv6 IS-IS between an MCE and a PE
Step
1. Enter system view.
2. Create an IS-IS process for
an IPv6 VPN instance and
enter IS-IS view.
3. Configure a network entity
title.
4. Create the IS-IS IPv6 unicast
address family and enter its
view.
5. Redistribute VPN routes.
6. Return to system view.
7. Enter interface view.
8. Enable the IPv6 IS-IS
process on the interface.
Configuring EBGP between an MCE and a PE
Step
1. Enter system view.
Command
router-id router-id
vpn-instance-capability simple
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ allow-direct | cost
cost-value | nssa-only |
route-policy route-policy-name |
tag tag | type type ] *
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
address-family ipv6 [ unicast ]
import-route protocol
[ process-id ] [ allow-ibgp ]
[ allow-direct | cost cost-value |
[ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name |
tag tag ] *
quit
interface interface-type
interface-number
isis ipv6 enable [ process-id ]
Command
system-view
453
Remarks
N/A
By default, routing loop detection
is enabled.
On an MCE network, you must
disable routing loop detection for
a VPN OSPFv3 process.
Otherwise, the MCE does not
receive OSPFv3 routes from the
PE.
By default, no routes are
redistributed into OSPFv3.
N/A
N/A
By default, OSPFv3 is disabled on
an interface.
Remarks
N/A
N/A
By default, no NET is configured.
By default, the IS-IS IPv6 unicast
address family is not created.
By default, IPv6 IS-IS does not
redistribute routes from any other
routing protocol.
If you do not specify the route
level in the command, the
command redistributes routes to
the level-2 routing table.
N/A
N/A
By default, no IPv6 IS-IS process
is enabled on the interface.
Remarks
N/A