Ethernet Service Instance And Vsi Binding Configuration Example - HP FlexNetwork 10500 Series Configuration Manual

Ethernet service instance and VSI binding configuration
example
Network requirements
As shown in
Configure a VSI on each PE, and establish LDP PWs between the PEs to interconnect the CEs.
Configure an Ethernet service instance on GigabitEthernet 1/0/1 of each PE to match packets with
VLAN ID 100. Bind the Ethernet service instance to the VSI to forward the matching packets through
the VSI.
Figure 107 Network diagram
VPN 1
Configuration procedure
Before configuration, disable the spanning tree feature globally or map each VLAN to an MSTI. For
more information, see Layer 2—LAN Switching Configuration Guide.
1. Configure an IGP and public tunnels on each PE. (Details not shown.)
2. Configure PE 1:
# Configure basic MPLS.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
# Enable L2VPN.
[PE1] l2vpn enable
# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish PWs to PE 2
and PE 3.
[PE1] vsi aaa
[PE1-vsi-aaa] pwsignaling ldp
[PE1-vsi-aaa-ldp] peer 3.3.3.9 pw-id 500
[PE1-vsi-aaa-ldp-3.3.3.9-500] quit
Figure 107, CE 1, CE 2, and CE 3 access PE 1, PE 2, and PE 3 in VLAN mode.
PE 1
GE1/0/1
Loop0
1.1.1.9/32
CE 1
Loop0
3.3.3.9/32
CE 3
GE1/0/1
PE 3
PE 2
GE1/0/1
Loop0
2.2.2.9/32
408
VPN 1
VPN 1
CE 2