Enabling Ldp; Enabling Ldp Globally; Enabling Ldp On An Interface - HP FlexNetwork 10500 Series Configuration Manual

Tasks at a glance
(Optional.) Configuring LDP NSR
(Optional.) Configuring LDP-IGP synchronization
(Optional.) Configuring LDP FRR
(Optional.) Setting a DSCP value for outgoing LDP packets
(Optional.) Resetting LDP sessions
(Optional.) Enabling SNMP notifications for LDP

Enabling LDP

To enable LDP, you must first enable LDP globally. Then, enable LDP on relevant interfaces or
configure IGP to automatically enable LDP on those interfaces.

Enabling LDP globally

Step
1. Enter system view.
2. Enable LDP for the local
node or for a VPN.
3. Configure an LDP LSR ID.

Enabling LDP on an interface

Step
1. Enter system view.
2. Enter interface view.
3. Enable IPv4 LDP on the
interface.
4. Enable IPv6 LDP on the
interface.
Command
system-view
•
Enable LDP for the local node
and enter LDP view:
mpls ldp
•
Enable LDP for a VPN and enter
LDP-VPN instance view:
a. mpls ldp
b. vpn-instance
vpn-instance-name
lsr-id lsr-id
Command
system-view
interface interface-type
interface-number
mpls ldp enable
mpls ldp ipv6 enable
26
Remarks
N/A
By default, LDP is globally
disabled.
By default, the LDP LSR ID is
the same as the MPLS LSR ID.
Remarks
N/A
If the interface is bound to a VPN
instance, you must enable LDP
for the VPN instance by using
the vpn-instance command in
LDP view.
By default, IPv4 LDP is disabled
on an interface.
By default, IPv6 LDP is disabled
on an interface.