HP FlexNetwork 10500 Series Configuration Manual page 154

Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 1911 bytes/sec, 15288 bits/sec, 0 packets/sec
Input: 0 packets input, 0 bytes, 0 drops
Output: 1526 packets output, 22356852 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel interface on Switch A.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: Disabled
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
5. Configure auto FRR on Switch B (the PLR):
# Enable the automatic bypass tunnel setup feature globally.
[SwitchB] mpls te
[SwitchB-te] auto-tunnel backup
# Specify interface numbers 50 to 100 for the automatically created bypass tunnels.
[SwitchB-te-auto-bk] tunnel-number min 50 max 100
[SwitchB-te-auto-bk] quit
: Tunnel 1
: Up (Main CRLSP up, Shared-resource CRLSP down)
:
: 16802 Tunnel ID
: Normal
: 2.2.2.2 Egress LSR ID
: RSVP-TE Static CRLSP Name
: SE
: -
: -
: - Reverse-LSP Tunnel ID: -
: CT0 Tunnel Bandwidth
: 0 kbps
: 7 Holding Priority
: 0/0
: exp1
: TE
: Enabled Record Label
: Enabled Bandwidth Protection : Disabled
Backup Bandwidth Type: -
: -
: No Auto Created
: Disabled
: 3 Retry Interval
: Disabled Reoptimization Freq
: None Backup LSP ID
: Disabled Auto Bandwidth Freq
: - Max Bandwidth
: -
145
: 1
: 4.4.4.4
: -
: 0 kbps
: 7
: Enabled
: No
: 2 sec
: -
: -
: -
: -