Configuring Bgp As Number Substitution And Soo Attribute - HP FlexNetwork 10500 Series Configuration Manual

Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
# Verify that VLAN-interface 12 of CE 1 and VLAN-interface 13 of CE 2 can ping each other. (Details
not shown.)

Configuring BGP AS number substitution and SoO attribute

Network requirements
CE 1, CE 2, and CE 3 belong to VPN 1, and are connected to PE1, PE 2, and PE 3. CE 1 and CE 2
reside in the same site. CE1, CE2, and CE 3 all use AS number 600.
To avoid route loss, configure BGP AS number substitution on PEs.
To avoid routing loops, configure the same SoO attribute on PE 1 and PE 2 for CE 1 and CE 2.
Figure 83 Network diagram
Loop0
VPN 1
AS 600
Table 29 Interface and IP address assignment
Device
CE 1
CE 2
PE 1
: NULL0
: ::
: NULL0
: ::
: NULL0
CE 1
Vlan-int2
Vlan-int2
Loop0 Vlan-int3
Vlan-int4
PE 1
PE 2
Vlan-int4
Loop0 Vlan-int5
Vlan-int2
CE 2
Vlan-int2
Interface IP address
Loop0 100::1/96
Vlan-int2 10:1::1/96
Vlan-int2 10:2::1/96
Loop0 1.1.1.9/32
Vlan-int2 10:1::2/96
Vlan-int3 30.1.1.1/24
MPLS backbone
AS 100
Loop0
Vlan-int3
Vlan-int6
Vlan-int6
Vlan-int5
P
Device
CE 3
PE 2
320
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Loop0
Vlan-int7
PE 3
CE 3
Vlan-int7
VPN 1
AS 600
Interface IP address
Loop0 200::1/96
Vlan-int7 10:3::1/96
Loop0 2.2.2.9/32
Vlan-int2 10:2::2/96
Vlan-int4 40.1.1.2/24
Vlan-int5 50.1.1.1/24
Loop0