Configuring A Remote Ccc Connection - HP FlexNetwork 10500 Series Configuration Manual

# Verify that a BGP PW has been established on PE 2.
<PE2> display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: vpnb
Peer
192.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring a remote CCC connection

Network requirements
Create a remote CCC connection between PE 1 and PE 2 to allow communication between CE 1
and CE 2 within VLAN 10.
Create Ethernet service instance 10 on GigabitEthernet 1/0/1 to match packets with an outer VLAN
ID of 10 on each PE.
Figure 93 Network diagram
GE1/0/1
Site 1
CE 1
Table 34 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
Configuration procedure
1. Configure VLANs and add ports to VLANs on each switch. (Details not shown.)
2. Configure CE 1.
<CE1> system-view
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
PW ID/Rmt Site
1
MPLS or IP backbone
Loop0
Vlan-int20
Vlan-int20
PE 1
Vlan-int10
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int20 10.1.1.1/24
Vlan-int10 100.1.1.2/24
In/Out Label Proto
1025/1036 BGP
Loop0 Loop0
Vlan-int30
Vlan-int30
P PE 2
Device
P
PE 2
352
Flag Link ID
M 1
GE1/0/1
Vlan-int10
Site 2
CE 2
Interface IP address
Loop0 192.4.4.4/32
Vlan-int20 10.1.1.2/24
Vlan-int30 10.2.2.2/24
Loop0 192.3.3.3/32
Vlan-int30 10.2.2.1/24
State
Up