HP FlexNetwork 10500 Series Configuration Manual page 140

Current state: UP
Line protocol current state: UP
Description: Tunnel4 Interface
Bandwidth: 64kbps
Maximum transmission unit: 1496
Internet address: 8.1.1.1/24 (primary)
Tunnel source unknown, destination 1.1.1.9
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets input, 0 bytes, 0 drops
Output: 0 packets output, 0 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel on Switch D.
[SwitchD] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: -
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
# Display detailed information about the bidirectional MPLS TE tunnel on Switch D.
[SwitchD] display mpls lsp verbose
: Tunnel 4
: Up (Main CRLSP up, Reverse CRLSP up)
:
: - Tunnel ID
: Normal
: - Egress LSR ID
: RSVP-TE Static CRLSP Name
: FF
: Co-routed, passive
: -
: 1.1.1.9 Reverse-LSP Tunnel ID: 1
: - Tunnel Bandwidth
: -
: - Holding Priority
: -/-
: -
: -
: - Record Label
: - Bandwidth Protection : -
Backup Bandwidth Type: -
: -
: - Auto Created
: -
: - Retry Interval
: - Reoptimization Freq
: - Backup LSP ID
: - Auto Bandwidth Freq
: - Max Bandwidth
: -
131
: 8
: -
: -
: -
: -
: -
: No
: -
: -
: -
: -
: -