HP FlexNetwork 10500 Series Configuration Manual page 152

Table 8 Interface and IP address assignment
Device
Switch A
Switch B
Switch D
Configuration procedure
Before configuration, disable the spanning tree feature globally or map each VLAN to an MSTI. For
more information, see Layer 2—LAN Switching Configuration Guide.
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address.
(Details not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each switch. Enable BFD
for RSVP-TE on Switch B and Switch C:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] mpls lsr-id 1.1.1.1
[SwitchA] mpls te
[SwitchA-te] quit
[SwitchA] rsvp
[SwitchA-rsvp] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] mpls enable
[SwitchA-Vlan-interface1] mpls te enable
[SwitchA-Vlan-interface1] rsvp enable
[SwitchA-Vlan-interface1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] mpls lsr-id 2.2.2.2
[SwitchB] mpls te
[SwitchB-te] quit
[SwitchB] rsvp
[SwitchB-rsvp] quit
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] mpls enable
[SwitchB-Vlan-interface1] mpls te enable
[SwitchB-Vlan-interface1] rsvp enable
[SwitchB-Vlan-interface1] quit
Interface IP address
Loop0 1.1.1.1/32
Vlan-int1 2.1.1.1/24
Loop0 2.2.2.2/32
Vlan-int1 2.1.1.2/24
Vlan-int2 3.1.1.1/24
Vlan-int4 3.2.1.1/24
Vlan-int6 3.3.1.1/24
Loop0 4.4.4.4/32
Vlan-int3 4.1.1.2/24
Vlan-int7 4.2.1.2/24
Device Interface
Switch E Loop0
Vlan-int4
Vlan-int5
Switch C Loop0
Vlan-int3
Vlan-int2
Vlan-int5
Switch F Loop0
Vlan-int6
Vlan-int7
143
IP address
5.5.5.5/32
3.2.1.2/24
3.4.1.1/24
3.3.3.3/32
4.1.1.1/24
3.1.1.2/24
3.4.1.2/24
6.6.6.6/32
3.3.1.2/24
4.2.1.1/24