Configuring Rsvp Refresh; Configuring Rsvp Srefresh And Reliable Rsvp Message Delivery; Configuring Rsvp Hello Extension - HP FlexNetwork 10500 Series Configuration Manual

Configuring RSVP refresh

Step
1. Enter system view.
2. Enter RSVP view.
3. Set the refresh interval for
Path and Resv messages.
4. Set the PSB and RSB
timeout multiplier.
Configuring RSVP Srefresh and reliable RSVP
message delivery
After Srefresh is enabled, RSVP maintains the path and reservation states by sending Srefresh
messages rather than standard refresh messages.
To configure Srefresh and reliable RSVP message delivery:
Step
1. Enter system view.
2. Enter interface view.
3. Enable Srefresh and reliable
RSVP message delivery.
4. Set the retransmission
increment value for reliable
RSVP message delivery.
5. Set the retransmission
interval for reliable RSVP
message delivery.

Configuring RSVP hello extension

When RSVP hello extension is enabled on an interface, the device receives and sends hello
messages through the interface to detect the neighbor's status.
Command
system-view
rsvp
refresh interval interval
keep-multiplier number
Command
system-view
interface interface-type
interface-number
rsvp reduction srefresh
[ reliability ]
rsvp reduction retransmit
increment increment-value
rsvp reduction retransmit
interval interval
167
Remarks
N/A
N/A
By default, the refresh interval is
30 seconds for both path and
Resv messages.
By default, the PSB and RSB
timeout multiplier is 3.
Remarks
N/A
N/A
By default, Srefresh and reliable
RSVP message delivery are
disabled.
By default, the RSVP message
retransmission increment is 1.
This command takes effect after
reliable RSVP message delivery
is enabled by using the rsvp
reduction srefresh reliability
command.
By default, the RSVP message
retransmission interval is 500
milliseconds.
This command takes effect after
reliable RSVP message delivery
is enabled by using the rsvp
reduction srefresh reliability
command.