Binding An Ethernet Service Instance To A Cross-Connect - HP FlexNetwork 10500 Series Configuration Manual

Step
4. Create a remote CCC
connection.
Binding an Ethernet service instance to a
cross-connect
IMPORTANT:
This task is mutually exclusive with Ethernet link aggregation. If a Layer 2 Ethernet interface has
been added to a link aggregation group, you cannot bind an Ethernet service instance on the Layer
2 interface to a cross-connect, and vice versa.
On a Layer 2 Ethernet or Layer 2 aggregate interface, you can create an Ethernet service instance
and bind it to a cross-connect. The Ethernet service instance matches packets received on that
interface. The matching packets are then forwarded to the bound PW or another AC. An Ethernet
service instance can match all packets, tagged packets, or untagged packets.
When you bind an Ethernet service instance to a cross-connect, you can associate Track with the
Ethernet service instance. Then, the Ethernet service instance is up only when one or more of the
associated track entries are positive.
To bind an Ethernet service instance to a non-BGP cross-connect:
Step
1. Enter system view.
2. Enter cross-connect group
view.
3. Enter cross-connect view.
4. Bind the Ethernet service
instance on the interface to
the cross-connect.
To bind an Ethernet service instance to a BGP cross-connect:
Step
1. Enter system view.
2. Enter cross-connect group
view.
Command
ccc in-label in-label-value out-label
out-label-value { nexthop nexthop |
out-interface interface-type
interface-number } [ pw-class
class-name ]
Command
system-view
xconnect-group group-name
connection connection-name
ac interface interface-type
interface-number
service-instance instance-id
[ access-mode { ethernet |
vlan } ] [ track
track-entry-number&<1-3> ]
Command
system-view
xconnect-group group-name
336
Remarks
By default, no remote CCC
connections exist.
Use the out-interface keyword
to specify the outgoing interface
only on a point-to-point link. On
other types of interfaces such as
Layer 3 Ethernet interface,
VLAN interface, and Layer 3
aggregate interface, you must
use the nexthop keyword to
specify the IP address of the
next hop.
Remarks
N/A
N/A
N/A
By default, no Ethernet service
instance is bound to the
cross-connect.
Remarks
N/A
N/A