HP FlexNetwork 10500 Series Configuration Manual page 321

Table 27 Interface and IP address assignment
Device
CE 1
PE 1
Switch A
Configuration procedure
1. Configure OSPFv3 on the customer networks:
# Configure conventional OSPFv3 on CE 1, Switch A, and CE 2 to advertise subnet addresses
of the interfaces (see
# Set the cost value to 2 for both the link between CE 1 and Switch A, and the link between CE
2 and Switch A. (Details not shown.)
# Execute the display ipv6 routing-table command to verify that CE 1 and CE 2 have learned
the route to each other. (Details not shown.)
2. Configure IPv6 MPLS L3VPN on the backbone:
# Configure basic MPLS and MPLS LDP on PE 1 to establish LDP LSPs.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
[PE1] interface vlan-interface 12
[PE1-Vlan-interface12] ip address 10.1.1.1 24
[PE1-Vlan-interface12] mpls enable
[PE1-Vlan-interface12] mpls ldp enable
[PE1-Vlan-interface12] quit
# Configure PE 1 to take PE 2 as an MP-IBGP peer.
[PE1] bgp 100
[PE1-bgp-default] peer 2.2.2.9 as-number 100
[PE1-bgp-default] peer 2.2.2.9 connect-interface loopback 0
[PE1-bgp-default] address-family vpnv6
[PE1-bgp-default-vpnv6] peer 2.2.2.9 enable
[PE1-bgp-default-vpnv6] quit
[PE1-bgp-default] quit
# Configure OSPF on PE 1.
[PE1] ospf 1
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
Interface IP address
Vlan-int11 100::1/64
Vlan-int13 20::1/64
Loop0 1.1.1.9/32
Loop1 3::3/128
Vlan-int11 100::2/64
Vlan-int12 10.1.1.1/24
Vlan-int11 30::1/64
Vlan-int12 20::2/64
Table 27). (Details not shown.)
Device
CE 2
PE 2
312
Interface IP address
Vlan-int11 120::1/64
Vlan-int12 30::2/64
Loop0 2.2.2.9/32
Loop1 5::5/128
Vlan-int11 120::2/64
Vlan-int12 10.1.1.2/24