HP FlexNetwork 10500 Series Configuration Manual page 278

[PE1-bgp-default-ipv4-vpn1] quit
[PE1-bgp-default-vpn1] quit
# Specify the preferred value as 200 for BGP VPNv4 routes received from PE 2. This value is
greater than the preferred value (0) for IPv4 unicast routes from CE 2, so PE 1 prefers the
routes from PE 2.
[PE1-bgp-default] address-family vpnv4
[PE1-bgp-default-vpnv4] peer 3.3.3.3 preferred-value 200
[PE1-bgp-default-vpnv4] quit
[PE1-bgp-default] quit
Verifying the configuration
# Display detailed information about the route to 4.4.4.4/32 on PE 1. The output shows the backup
next hop for the route.
[PE1] display ip routing-table vpn-instance vpn1 4.4.4.4 32 verbose
Summary Count : 1
Destination: 4.4.4.4/32
Protocol: BGP
SubProtID: 0x1
Cost: 0
IpPre: N/A
Tag: 0
OrigTblID: 0x0
TableID: 0x102
NibID: 0x15000004
AttrID: 0x1
Flags: 0x110060
Label: 1275
BkLabel: NULL
Tunnel ID: 0x409
BkTunnel ID: Invalid
FtnIndex: 0x0
Connector: N/A
Process ID: 0
Age: 00h00m04s
Preference: 255
QosLocalID: N/A
State: Active Adv
OrigVrf: default-vrf
OrigAs: 300
LastAs: 300
Neighbor: 3.3.3.3
OrigNextHop: 3.3.3.3
RealNextHop: 172.3.1.3
BkNextHop: 10.1.1.1
Interface: Vlan-int15
BkInterface: Vlan-int13
TrafficIndex: N/A
269