Configuring Routing Between A Pe And A Ce - HP FlexNetwork 10500 Series Configuration Manual

Hide thumbs Also See for FlexNetwork 10500 Series:
Table of Contents

Advertisement

Step
2.
Enter VPN instance view or
VPN instance IPv6 VPN
view.
3.
Configure route targets.
4.
Set the maximum number of
active routes.
5.
Apply an import routing
policy.
6.
Apply an export routing
policy.
7.
Apply a tunnel policy to the
VPN instance.

Configuring routing between a PE and a CE

You can configure IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, EBGP, or IBGP between a PE and
a CE.
Command
Enter VPN instance view:
ip vpn-instance
vpn-instance-name
Enter VPN instance IPv6
VPN view:
a. ip vpn-instance
vpn-instance-name
b. address-family ipv6
vpn-target vpn-target&<1-8>
[ both | export-extcommunity |
import-extcommunity ]
routing-table limit number
{ warn-threshold | simply-alert }
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
274
Remarks
Configurations made in VPN
instance view apply to both IPv4
VPN and IPv6 VPN.
IPv6 VPN prefers the
configurations in VPN instance
IPv6 VPN view over the
configurations in VPN instance
view.
By default, no route targets are
configured.
By default, the number of active
routes is not limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from storing
too many routes.
By default, all routes matching the
import target attribute are
accepted.
Make sure the routing policy
already exists. Otherwise, the
device does not filter received
routes.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
Make sure the routing policy
already exists. Otherwise, the
device does not filter routes to be
advertised.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing). The
LSP tunnel takes precedence
over the CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see
"Configuring tunnel
policies."

Advertisement

Table of Contents
loading

Table of Contents