Configuring An Ldp Pw; Configuring A Bgp Pw - HP FlexNetwork 10500 Series Configuration Manual

Configuring an LDP PW

Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information
about MPLS LDP configuration, see
To configure an LDP PW:
Step
1. Enter system view.
2. Enter cross-connect group
view.
3. Enter cross-connect view.
4. Configure an LDP PW, and
enter cross-connect PW
view.

Configuring a BGP PW

To configure a BGP PW, perform the following configurations on PEs:
•
Configure BGP to advertise MPLS L2VPN label block information.
•
Create a BGP PW.
Configuring BGP to advertise MPLS L2VPN label block information
Step
1. Enter system view.
2. Enable BGP instance and
enter BGP instance view.
3. Configure the remote PE as a
BGP peer.
4. Create the BGP L2VPN
address family and enter BGP
L2VPN address family view.
5. Enable BGP to exchange BGP
L2VPN information with the
specified peer or peer group.
6. Enable BGP to exchange label
block information with the
specified peer or peer group.
"Configuring LDP."
Command
system-view
xconnect-group group-name
connection connection-name
peer ip-address pw-id pw-id
[ pw-class class-name |
tunnel-policy
tunnel-policy-name ] *
Command
system-view
bgp as-number [ instance
instance-name ]
[ multi-session-thread ]
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
address-family l2vpn
peer { group-name | ip-address
[ mask-length ] } enable
peer { group-name | ip-address
[ mask-length ] } signaling
[ non-standard ]
333
Remarks
N/A
N/A
N/A
By default, no LDP PWs exist.
After an LDP PW is created, the
PE automatically sends a targeted
hello to create an LDP session to
the peer PE. Then, the PE
exchanges the PW ID FEC and
PW label mapping with the peer.
Remarks
N/A
By default, BGP is disabled.
By default, no BGP peers
exist.
By default, no BGP L2VPN
address family exists.
By default, BGP cannot
exchange BGP L2VPN
information with any peer or
peer group.
By default, BGP can
exchange label block
information with a BGP
L2VPN peer or peer group by
using RFC 4761
MP_REACH_NLRI.