HP FlexNetwork 10500 Series Configuration Manual page 170

Description: Tunnel1 Interface
Bandwidth: 64kbps
Maximum transmission unit: 1496
Internet address: 6.1.1.1/24 (primary)
Tunnel source unknown, destination 3.3.3.3
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel on Switch A.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Type: -
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
# Display static CRLSP information on each switch.
[SwitchA] display mpls lsp
FEC
1.1.1.1/0/1
2.1.1.2
[SwitchB] display mpls lsp
: Tunnel 1
: Up (Main CRLSP up)
:
: 1 Tunnel ID
: Normal
: 1.1.1.1 Egress LSR ID
: Static Static CRLSP Name
: -
: -
: -
: - Reverse-LSP Tunnel ID: -
: - Tunnel Bandwidth
: -
: 0 Holding Priority
: -/-
: -
: TE
: - Record Label
: - Backup Bandwidth Flag: -
Backup Bandwidth
: -
: 3 Retry Interval
: - Reoptimization Freq
: - Backup LSP ID
: - Auto Bandwidth Freq
: - Max Bandwidth
: -
Proto In/Out Label
StaticCR -/20
Local -/-
161
: 0
: 3.3.3.3
: static-cr-lsp-1
: -
: 0
: -
: -
: 2 sec
: -
: -
: -
: -
Interface/Out NHLFE
Vlan1
Vlan1