Configuring Ldp Pw Redundancy - HP FlexNetwork 10500 Series Configuration Manual

Step
6. Configure a backup static PW
and enter VSI static backup
PW view.
7. Return to user view.
8. Manually switch traffic of the
PW to its backup PW.

Configuring LDP PW redundancy

Step
1. Enter system view.
2. Enter VSI view.
3. Specify LDP signaling for
PWs, and enter VSI LDP
signaling view.
4. (Optional.) Specify the
switchover mode and set the
wait time for the switchover.
5. Configure an LDP PW and
enter VSI LDP PW view.
6. Configure a backup LDP PW
and enter VSI LDP backup
PW view.
7. Return to user view.
8. Manually switch traffic of the
PW to its backup PW.
Command
backup-peer ip-address [ pw-id
pw-id ] in-label label-value
out-label label-value [ pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
return
l2vpn switchover peer
ip-address pw-id pw-id
Command
system-view
vsi vsi-name
pwsignaling ldp
revertive { wtr wtr-time | never }
peer ip-address [ pw-id pw-id ]
[ no-split-horizon | pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
backup-peer ip-address [ pw-id
pw-id ] [ pw-class class-name |
tunnel-policy tunnel-policy-name ]
*
return
l2vpn switchover peer ip-address
pw-id pw-id
385
Remarks
By default, no backup static PW
exists.
If both the default PW ID in the
default-pw-id command and a
PW ID in the backup-peer
command are configured, the PW
ID in the backup-peer command
is used. If only the default PW ID is
configured, the default PW ID is
used. If no default PW ID is
configured, you must provide a
PW ID in the backup-peer
command.
N/A
N/A
Remarks
N/A
N/A
By default, no PW signaling
protocol is specified for the VSI.
By default, the switchover mode
is revertive and the switchover
wait time is 0 seconds.
By default, no LDP PWs exist.
By default, no backup LDP PW
exists.
If both the default PW ID in the
default-pw-id command and a
PW ID in the backup-peer
command are configured, the
PW ID in the backup-peer
command is used. If only the
default PW ID is configured, the
default PW ID is used. If no
default PW ID is configured, you
must provide a PW ID in the
backup-peer command.
N/A
N/A