Configuring Routing Between An Mce And A Pe - HP FlexFabric 5940 Configuration Manual

Step
3. Configure the MCE as an
IBGP peer.
4. Enter BGP-VPN IPv4
unicast address family
view.
5. Enable BGP to exchange
IPv4 unicast routes with the
peer.
6. Redistribute the IGP routes
of the VPN into BGP.

Configuring routing between an MCE and a PE

MCE-PE routing configuration includes these tasks:
•
Binding the MCE-PE interfaces to VPN instances.
•
Performing route configurations.
•
Redistributing VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configurations on the MCE. For information about configuring the PE, see the
documentation for the PE.
Configuring static routing between an MCE and a PE
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
3. (Optional.) Set the
default preference for
static routes.
Configuring RIP between an MCE and a PE
Step
1. Enter system view.
2. Create a RIP process for
a VPN instance and enter
RIP view.
3. Enable RIP on the
interface attached to the
specified network.
4. Redistribute the VPN
Command
peer { group-name |
ipv4-address [ mask-length ] }
as-number as-number
address-family ipv4 [ unicast ]
peer { group-name |
ipv4-address [ mask-length ] }
enable
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value
| route-policy
route-policy-name ] * ]
Command
system-view
ip route-static vpn-instance s-vpn-instance-name
dest-address { mask-length | mask } { interface-type
interface-number [ next-hop-address ] |
next-hop-address [ public ] [ track
track-entry-number ] | vpn-instance
d-vpn-instance-name next-hop-address [ track
track-entry-number ] } [ permanent ] [ preference
preference ] [ tag tag-value ] [ description text ]
ip route-static default-preference
default-preference
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id |
11
Remarks
By default, no BGP peers or
peer groups exist.
N/A
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
By default, no routes are
redistributed into BGP.
A VPN site must advertise VPN
network addresses to the
connected MCE.
Remarks
N/A
By default, no
static routes are
configured.
The default
preference is 60.
Remarks
N/A
N/A
By default, RIP is disabled on
an interface.
By default, no routes are