Timing Chart - Mitsubishi MR-JE-10A Instruction Manual

3. SIGNALS AND WIRING

3.10.2 Timing chart

(1) When you use the forced stop deceleration function
(a) SON (Servo-on) on/off
When SON (Servo-on) is turned off, the servo lock will be released after Tb [ms], and the servo
motor will coast. If the electromagnetic brake is enabled during servo-lock, the brake life may be
shorter. Therefore, set Tb about 1.5 times of the minimum delay time where the moving part will not
drop down for a vertical axis system, etc.
Servo motor speed
0 r/min
ON
Base circuit
OFF
MBR
ON
(Note 1)
(Electromagnetic
OFF
brake interlock)
ON
SON (Servo-on)
OFF
Position command
0 r/min
(Note 4)
Release
Electromagnetic
brake
Activate
Note 1. ON: Electromagnetic brake is not activated.
OFF: Electromagnetic brake has been activated.
2. Electromagnetic brake is released after the release delay time of electromagnetic brake and operation time of external circuit
relay, etc. For the release delay time of electromagnetic brake, refer to "HG-KN/HG-SN Servo Motor Instruction Manual".
3. Give a position command after the electromagnetic brake is released.
4. This is in position control mode.
POINT
To enable the function, set "2 _ _ _ (initial value)" in [Pr. PA04].
Tb [Pr. PC16 Electromagnetic brake sequence output]
Approx. 95 ms
Approx. 95 ms
(Note 3)
Release delay time and external relay, etc. (Note 2)
3 - 62
Coasting
Operation delay time of
the electromagnetic brake