Source I/O Interfaces - Mitsubishi MR-JE-10A Instruction Manual

3. SIGNALS AND WIRING

3.9.3 Source I/O interfaces

In this servo amplifier, source type I/O interfaces can be used.
(1) Digital input interface DI-1
This is an input circuit whose photocoupler anode side is the input terminal. Transmit signals from
source (open-collector) type transistor output, relay switch, etc.
The following shows when the CN1-37 pin and the CN1-38 pin are used as digital input interface:
(2) Digital output interface DO-1
This is a circuit in which the emitter side of the output transistor is the output terminal. When the output
transistor is turned on, the current flows from the output terminal to a load.
A maximum of 2.6 V voltage drop occurs in the servo amplifier.
For transistor
TR Switch
Approximately DC 24 V ± 10%
5 mA 300 mA
V 1.0 V
CES
I 100 A
CEO
Switch
Switch
24 V DC ± 10%
300 mA
Servo amplifier
ALM
etc.
DOCOM
Note. If the voltage drop (maximum of 2.6 V) interferes with the relay operation, apply high
voltage (maximum of 26.4 V) from external source.
3 - 58
Servo amplifier
EM2
etc.
Approximately
6.2 kΩ
DICOM
Servo amplifier
PG
PP2
Approximately
1.2 kΩ
(CN1-37)
NG
NP2 Approximately
1.2 kΩ
(CN1-38)
SD
If polarity of diode is
reversed, servo amplifier
will malfunction.
Load
(Note) 24 V DC ± 10%
300 mA