Mitsubishi MR-JE-10A Instruction Manual page 264

11. OPTIONS AND PERIPHERAL EQUIPMENT
To remove the built-in regenerative resistor mounted on the back of MR-JE-40A to MR-JE-100A, follow
the procedures 1) to 3) with referring the illustration.
1) Disconnect the wirings of the built-in regenerative resistor from the power connector (CNP1).
(Refer to (3) (b) of 3.3.2.)
2) Remove the wirings of the built-in regenerative resistor from the closest position to the power
connector (CNP1) in order. Please pay full attention not to break the wirings.
3) Remove the screw fixing the built-in regenerative resistor and dismount the built-in regenerative
resistor.
1)
Note. Screw size: M3
Tightening torque: 0.72 [N•m]
11 - 9
(Note)
3)
2)