Junction Terminal Block Mr-Tb50 - Mitsubishi MR-JE-10A Instruction Manual

11. OPTIONS AND PERIPHERAL EQUIPMENT

11.3 Junction terminal block MR-TB50

(1) Usage
Always use the junction terminal block (MR-TB50) with the option cable (MR-J2M-CN1TBL_M) as a set.
Install the junction terminal block cable on the junction terminal block side with the supplied cable clamp
fitting (AERSBAN-ESET). For the use of the cable clamp fitting, refer to section 11.9, (2) (c).
(2) Terminal block label
Use the following for the terminal label. For the input/output pin assignment in the control mode, refer to
(4) (b) of this section.
(3) Dimensions
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 3133
2 4 6 8 10 12 14 16 1820 22 24 26 28 30 32
Servo amplifier
CN1
Junction terminal
block cable
(MR-J2M-CN1TBL_M)
235
2
1
MITSUBISHI
MR-TB50
34 36 38 40 42 44 46 48 50
244
11 - 13
Junction terminal block
MR-TB50
Cable clamp
50
49
35 37 39 41 43 45 47 49
Terminal screw: M3.5
Applicable wire: 2 mm
Crimp terminal width: 7.2 mm or shorter
[Unit: mm]
2- 4.5
46.5
2