User Settings; Welding System Settings - Kemppi A7 MIG Welder 350 Operating Manual

4.2.4 User settings

User settings menu (Main menu 2/8) (login required)*
Menu item Value range
1/5 Change PIN
code
New PIN code 0000 - 9999
2/5 User mode ON, OFF
3/5 Set the user
rights
Select user USER1 - USER10
Level Welder,
Supervisor,
Administrator
4/5 User activation
User activation USER1 - USER10
User Enabled,
Disabled
5/5 Reset user PIN
code
Select user USER1 - USER10
* See section 4.4 User identification for more information.
Factory value Description
Change your PIN code.
0000 Specify a new PIN code.
OFF Set the user identification mode
on and off.
Change the role for a user.
Select the user whose role you
want to change. Note! You cannot
change your own role.
Select the role for the user.
Create and delete users.
Select the user account that you
want to create /delete.
Create an account by setting
the user Enabled, or delete the
account by selecting Disabled.
Reset the PIN code of a user.
Select the user whose pin code
to reset. The reset value is 0000.
Confirm the reset by pressing OK
soft button.
© Kemppi Oy 2017

4.2.5 Welding system settings

System config menu (Main menu 4/8)
Menu item Value range
1/20 Water cooling OFF, ON, AUTO
2/20 Cable length 10 - 100 m
3/20 FineCalib 0 V - 10 V /
100 A
4/20 System clock
5/20 Device information
6/20 Restore settings
ROBOT All settings
Restore to factory
22
A7 MIG Welder
Factory Description
value
AUTO Set the water cooler on and
off, or let the system control
the cooler (AUTO). In auto
mode the water pump starts
when welding starts and
stops after a delay when
welding stops.
10 m Set the welding circuit length
for optimal arc control.
10 V / 100 A Set the compensation for
cable resistance variation.
View and modify the system
time and date.
Review the following device
information for each device
in the system:
DevSW: Unit software
version.
SysSW: System base software
version.
BootSW: Boot software
version.
SW Item: Software item
number.
Serial: Device serial number.
Prog: Programmer name.
Date: Programming date.
All memory channels (0-199)
are restored from backup.
Setup settings remain as they
are.
All memory channels and
their backups are removed.
All settings are set to default
factory values.
1735