Table of Contents
Advertisement
7/20
License menu
License code
License timers
8/20
Weld data delay
1 - 60 s
9/20
Display delay
1 - 20
10/20
Pre gas time
0.0 - 9.9 s,
CURVE
11/20
Post gas time
0.0 - 9.9 s,
CURVE
Enter a license code
manually:
• Up and down arrows are
used to select the code
number index.
• Control knob is used to
select the code number
(0-255).
• ENTER soft button is used
to activate the license code
after all numbers have
been entered.
Check the remaining license
time of the time-based Wise
features.
20 s
Specify how long the Weld
Data is displayed after
welding stops. Weld Data
display can be closed by
turning the control knob or
pressing any button.
10
Specify how long any
textual information (like
"Settings saved") is displayed
on the screen. This is an
approximate time value and
the actual delay may vary
depending on the system
load.
CURVE
Override the pre gas time of
the welding curve, or let the
system use the curve value.
CURVE
Override the post gas time of
the welding curve, or let the
system use the curve value.
© Kemppi Oy 2017
12/20
Control
*
USER, PANEL,
REMOTE, GUN
*
13/20
RemoteAutoRecog
ON, OFF
14/20
MIG CurrentDisp
ON, OFF
15/20
WFMotorWarnLev
1.5 - 5.0 A
16/20
WF end step
ON, OFF
17/20
AutoWireInch
*
ON, OFF
23
A7 MIG Welder
USER
Select which remote control
is used, or let the user choose
the remote control freely.
ON
Set the automatic
recognition of the remote
control unit on and off.
OFF
Set the MIG current display
on and off. When the MIG
current display is off, the
wire feed speed is displayed
instead.
3.5 A
Set the warning level of
the wire feeding motor
current. The setting affects
how sensitively the system
detects issues in the wire
feeding system.
OFF
Set the wire feeding end
step on and off. When the
setting is on, the filler wire
steps forward at the end of
the welding cycle. Otherwise
the filler wire remains in the
position where it was driven
during the welding cycle.
ON
Set the automatic
SuperSnake wire inch
feature on and off. When the
setting is on, the filler wire is
driven automatically to the
SuperSnake by pressing the
wire inch button.
1735
Advertisement
Table of Contents
