I/O Device Errors - Kemppi A7 MIG Welder 350 Operating Manual

5.2.6 I/O device errors

Code Description
201 INPUT 1 ERROR
Input 1 reported an error.
202 INPUT 2 ERROR
Input 2 reported an error.
203 INPUT 3 ERROR
Input 3 reported an error.
204 INPUT 4 ERROR
Input 4 reported an error.
205 INPUT 5 ERROR
Input 5 reported an error.
206 INPUT 6 ERROR
Input 6 reported an error.
207 INPUT 7 ERROR
Input 7 reported an error.
208 INPUT 8 ERROR
Input 8 reported an error.
209 INPUT 1 WARNING
Input 1 reported a warning.
210 INPUT 2 WARNING
Input 2 reported a warning.
211 INPUT 3 WARNING
Input 3 reported a warning.
212 INPUT 4 WARNING
Input 4 reported a warning.
213 INPUT 5 WARNING
Input 5 reported a warning.
214 INPUT 6 WARNING
Input 6 reported a warning.
215 INPUT 7 WARNING
Input 7 reported a warning.
216 INPUT 8 WARNING
Input 8 reported a warning.
Severity Measures
Error In addition to an ordinary input signal function, each input of
the I/O device can be configured to report an error or a warning
when the input status changes. The warning is just a notification
Error
from an event - it does not prevent the operation of the welding
system. After clearing its cause, the warning state can be cleared.
Error
The error stops welding and prevents operation of the welding
system until the situation is cleared and the error state is reset.
Both warnings and errors are recorded into the logbook.
Error
See the A7 MIG Welder Integration guide for more information on
the input configuration.
Error
Error
Error
Error
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
© Kemppi Oy 2017
59
A7 MIG Welder 1735