Table of Contents
Advertisement
Welding parameters and functions
Figure 4.10 Memory channel editing – Welding parameters and functions view
In the
Welding parameters
view you can, depending on the selected welding process,
• set the min, max and initial values for
• set the min, max and initial values for
• set the value for the
Dynamics
• set the value manually or from the curve for
Double pulse
frequency.
In the
Welding functions
menu you can, depending on the selected welding process,
• select
Wise functions
on and off and set up their effectiveness.
• select
Hot start
option OFF, ALWAYS ON or USER SETS ON/OFF and set
start level
and
Hot start time
by using the sliders.
• select
Crater fill
option OFF, ALWAYS ON or USER SETS ON/OFF and set
fill step
level,
Crater fill end level
• select
Creep start
option CURVE or SET VALUE and set
using the sliders.
• select
Start power level
by using the slider.
• select
Touch sense ignition
option OFF or ON
Wire feed
speed.
Fine tuning
or Voltage.
and
Pulse
current.
Double pulse amplitude
and
and
Crater fill
time by using the sliders.
Creep start level
© Kemppi Oy 2017
Welding settings – Welding system
Figure 4.11 Welding system settings view
In the
Welding system
view you can modify all settings related to the behavior and
function of the welding system.
In the
General settings
menu you can
• turn
Water cooling
• adjust
Welding cable length
• select
Fine tuning calibration point
• select
Arc voltage
Hot
In the
Wire feed settings
• adjust
Wire feed motor current warning level
Crater
• select
Wire feed end step
by
In the
Gas settings
menu you can
• select
Pre gas time
value by using the slider bar.
32
A7 MIG Welder
ON, OFF and AUTO by clicking on the buttons.
by using the slider bar.
by using the slider bar.
measurement ON and OFF by clicking on the button.
menu you can
by using the slider bar.
ON and OFF by using the buttons.
and
Post gas time
CURVE or SET VALUE and adjusting the
1735
Advertisement
Table of Contents
