Installation - Kemppi A7 MIG Welder 350 Operating Manual

2.

INSTALLATION

The product is packed in specially designed transport
cartons. However, always make sure the products have not
been damaged during transportation prior to this.
Product packaging material is recyclable.
When moving the welding machine, never pull it from
the welding gun or other cables. For lifting the power source
and the robot interface unit, use the recesses at the both
ends of the robot interface unit.
Detailed installation instructions and the technical
information that is out of the scope of this manual are
found in the A7 MIG Welder Integration guide.
Operating environment
The machines included in the system are suitable for both
indoor and outdoor use. Always make sure that the air
flow to the machine is unrestricted. The recommended
operating temperature range is -20...+40°C.
Positioning the machines
Place the machine on a sturdy, level surface that is dry
and will not allow dust or other impurities to enter the
machine´s cooling air flow. Preferably, situate the machine
in a suitable carriage unit so it is above floor level.
• The surface inclination may not exceed
15 degrees.
• Ensure the free circulation of the cooling air.
There must be at least 20 cm of free space in
front of and behind the machine for cooling-air
circulation.
• Protect the machine against heavy rain and direct
sunshine.
Do not operate the machine in the rain.
Never aim the spray of sparks from a grinding machine
toward the equipment.
© Kemppi Oy 2017
5
A7 MIG Welder 1735