Kemppi A7 MIG Welder 350 Operating Manual page 27

Coll. sensor menu *
Selection ON, OFF
9/12
Switch type Opening, Closing
Output Low-act, High-act
*
Gas sensor menu
Enabled ON, OFF
10/12
Level 5.0 - 20.0 l/min
Gas type Unknown, CO2, Argon,
AR18CO2
Gun menu *
Gun type 0 (Normal),
1 (Binzel MasterPull),
11/12
2 (Binzel WHPP),
3 (Binzel WHPPi),
4 (Dinse MEP 200E)
Network settings *
DHCP enabled ON, OFF
IP address 0.0.0.0 - 255.255.255.254
12/12
Subnet mask 0.0.0.0 - 255.255.255.254
Gateway 0.0.0.0 - 255.255.255.254
* For more information, see the A7 MIG Welder Integration
Configure collision sensor. The collision sensor is an optional external device connected to the A7 MIG
Wire Feeder.
OFF Set the collision sensor on and off.
Closing Select the type of the electrical switch used in the signal line. The opening type switch opens the
electrical circuit of the signal line and the closing type switch closes the circuit.
High-act Select the polarity of the output signal in the robot interface. The low-active signal is logically '1' when
the signal level is 0 V and the high-active signal is '1' when the signal level is 24 V.
Configure gas sensor located in the A7 MIG Wire Feeder.
OFF Set the gas flow sensor on and off.
5.0 l/min Set the gas flow detection level.
Unknown Select the shielding gas type used for welding. This selection affects the correctness of the gas flow
measurement.
Configure the welding torch connected to the A7 MIG Wire Feeder.
0 (Normal) Select the type of the welding torch. Some torches have a push-pull motor, with or without a
tachometer. This selection enables use of certain push-pull torches.
Configure web user interface server's network settings. The server is located in the robot interface unit
of the A7 MIG Welder.
ON Switch the DHCP (dynamic host configuration protocol) client on for automatic IP settings or off for
manual (fixed) settings.
0.0.0.0 View the current IP address when teh DHCP is on, or specify the IP address manually when the DHCP is
off.
0.0.0.0 View the current subnet mask when the DHCP is on, or specify the subnet mask manually when the
DHCP is off.
0.0.0.0 View the current gateway when the DHCP is on. The Web UI does not use the gateway address, so it is
not necessary to set up this value when the DHCP is off.
guide.
27
© Kemppi Oy 2017 A7 MIG Welder 1735