eth switch shaper config
Configure common ingress shaper parameters.
SYNTAX:
eth switch shaper config
where:
shaper
unicast
multicast
broadcast
control
unknown
discard
normalize
exclude_ipg
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
shaper = <number{0-1}>
[unicast = <{enabled|disabled}>]
[multicast = <{enabled|disabled}>]
[broadcast = <{enabled|disabled}>]
[control = <{enabled|disabled}>]
[unknown = <{enabled|disabled}>]
[discard = <{enabled|disabled}>]
[normalize = <{enabled|disabled}>]
[exclude_ipg = <{enabled|disabled}>]
The shaper instance.
Shape unicast traffic.
Shape multicast traffic.
Shape broadcast traffic.
Shape MAC control traffic.
Shape traffic with unknown destination address.
Discard frame at overflow (else attempt for flow control).
Use relative speed calculations.
Exclude the Inter Packet Gap in the speed calculations.
ETH COMMANDS
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
473