Page 1
How to setup your Technicolor TG789vac Radio Fibre Router What is in the box? 1 Welcome letter including a setup guide sent by Call Flow Solutions • 1 Router • 1 Power Lead • 1 Red ended Ethernet Lead •...
Page 2
3. The lead then connects into the Radio’s power supply (Also known as an IDU). Alvarion The black Ethernet cable goes off to the aerial and must be in the ‘Radio’ port in the end of the power supply, this is placed at the top.
Page 3
4. If you wish to connect a device hardwired, you will need to use the Yellow Ethernet Lead provided with the router and connect it to one of the 4 ETH ports available. 5. Once all of the cables have been connected, you are now able to switch on the power on the router, leave the router for 10-15 minutes and once all of the lights are on like shown below, you are able to start using your broadband with Call Flow.