Ip Rtadd - Technicolor TG670 Cli Reference Manual

IP COMMANDS

ip rtadd

Add a route to the routing table.
SYNTAX:
ip rtadd
where:
dst
dstmsk
label
gateway
intf
srcintf
static
status
metric
596
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <{None|DSCP|Interactive|Management|
SIPS_RTP|SIPS_SIG|Video|VoIP-RTP|VoIP-Signal|
default}>]
[gateway = <ip-address>]
[intf = <{loop|ipsec0|Internet|lan1|wan1|dmz1|
guest1}>]
[srcintf = <{loop|ipsec0|Internet|lan1|wan1|
dmz1|guest1}>]
[static = <{enabled|disabled}>]
[status = <{up|down}>]
[metric = <number{0-255}>]
The destination IP address(es) using this route. Supports ip/
mask notation.
The destination IP address mask.
The name of a label.
The IP address of the next hop (direct connected gateway
or extended route)
Only for special interface routes : the outgoing IP interface
name.
Use this interface for source address selection.
Route persistency: static or dynamic (note that not all routes
can be changed).
The administrative state of the route.
The metric for this route (weight factor).
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL