Ip Ifconfig - Technicolor TG670 Cli Reference Manual

IP COMMANDS

ip ifconfig

Modify an IP interface configuration.
SYNTAX:
ip ifconfig
where:
intf
mtu
status
hwaddr
arpcachetimeout
group
linksensing
primary
mcastpromisc
symmetric
arpprobe
582
intf = <{loop|ipsec0|Internet|lan1|wan1|dmz1|
guest1}>
[mtu = <number{68-65535}>]
[status = <{down|up}>]
[hwaddr = <hardware-address>]
[arpcachetimeout = <number{0-7200}>]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[linksensing = <{disabled|enabled}>]
[primary = <{disabled|enabled}>]
[mcastpromisc = <{disabled|enabled}>]
[symmetric = <{disabled|enabled}>]
[arpprobe = <{unicast|broadcast}>]
An IP interface name.
The maximum packet size (including IP header) to use on
this interface.
The administrative state of the interface.
The hardware address (e.g. Ethernet MAC address) of this
interface.
Set the ARP cache timeout to be used for this interface (0 =
use global ARP cache timeout).
The group this interface belongs to. Can be used by e.g.
firewalling.
The IP interface's awareness of link state transitions.
Make the IP interface the primary interface.
Make the IP interface multicast promiscuous.
The routing mode of the IP interface.
The ARP mode of the interface.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL