Eth Oam Config - Technicolor TG670 Cli Reference Manual

eth oam config

Modify global E-OAM configuration.
SYNTAX:
eth oam config
where:
state
max-pdu-rate
mru
tx-timeout
ll-timeout
oui
vendor-code
mode
unidirectional
loopback
link-event
var-response
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
[state = <{disabled|enabled}>]
[max-pdu-rate = <number{1-100}>]
[mru = <number{64-1518}>]
[tx-timeout = <number{1-86400}>]
[ll-timeout = <number{1-86400}>]
[oui = <string>]
[vendor-code = <number or string>]
[mode = <{passive|active}>]
[unidirectional = <{disabled|enabled}>]
[loopback = <{disabled|enabled}>]
[link-event = <{disabled|enabled}>]
[var-response = <{disabled|enabled}>]
Enable/disable E-OAM.
Maximum number of PDUs per second.
Maximum Receive Unit.
Transmission timeout.
Local Lost Link timeout.
OUI to be used in Information OAM PDUs (system OUI if
left blank).
Vendor Specific Information.
E-OAM operational mode.
E-OAM unidirectional capability.
E-OAM loopback capability.
E-OAM link event capability.
E-OAM variable response capability.
ETH COMMANDS
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
443