Table of Contents
Advertisement
Figure 4-4
Device Type
MOSFET
Work Area
In this area, set the measurement conditions and observe the measurement results.
This is separated to the following areas.
•
"Setup" on page 4-11
•
"Characteristics" on page 4-20
•
"Connections" on page 4-24
Setup
Setup
This is an area to select the device type and its measured parameters, and enter your
measurement conditions.
Select the device type of your DUT from below.
•
"MOSFET"
•
"IGBT"
•
"Diode"
•
"Generic"
Select Generic to execute more general measurements for device other than
above types.
You can select one of the following capacitance and resistance parameter
measurements for "MOSFET" device type.
•
Ciss, Coss, Crss
Creates new settings to measure the characteristics of the input capacitance,
output capacitance, and reverse transfer capacitance for the drain-source voltage
in order.
•
Ciss
Creates new settings to measure the characteristics of the input capacitance for
the drain-source voltage.
Keysight B1507A User's Guide, Ed ition 1
Capacitance Measurement Software
GUI Reference
4- 11
Advertisement
Table of Contents
