Table of Contents
Advertisement
The following parameters can be shown or hidden by clicking the chevron
Details.
•
Resource/Output Mode/Output Sequence
You can change the settings of this terminal using the pull-down menu. For
details, see "Resource/Output Mode/Output Sequence" on page 4-50.
•
Base
Specify a pulse base voltage/current value.
•
Number of Step
Specify the number of sweep steps from start to stop.
•
Compliance
Specify a current/voltage compliance value.
If the output exceeds this, the sweep measurement is terminated.
•
Power Compliance
Specify the power compliance value.
To enable this, mark the check box.
If the output exceeds this, the sweep measurement is terminated.
Not available for HVSMU.
•
Voltage Compliance
Specify a voltage compliance value for UHCU.
To enable this, mark the check box.
If the output exceeds this, the sweep measurement is terminated.
Available for UHCU.
•
Peak Delay
Specify a delay time from the beginning point of the pulse period to the raising
point.
•
Peak Width
Specify a period of the pulse peak.
Keysight B1507A User's Guide, Ed ition 1
GUI Reference
I/V Measurement Software
of the
4- 49
Advertisement
Table of Contents
