Table of Contents
Advertisement
CAUTION
NOTE
Introduction
Test Fixture Front View
Lorsque vous touchez le MST après la mesure, élaborez une contre-mesure de
la charge résiduelle et du chauffage afin d'éviter tout choc électrique et toute
brûlure. Utilisez des gants et des outils. Prévoyez également du temps pour la
décharge et la radiation.
Never connect the terminals to any output, including circuit common and chassis
ground. Connecting other output may damage the connected one.
To use the 3-pin inline package socket module, attach it to the Base/Gate,
Collector/Drain, and Emitter/Source terminals. Then do not use the AC/DC Guard
terminal.
AC/DC Guard
Emitter/Source
If you do not use the 3-pin inline package socket module, connect your device under
test (DUT) to the terminals by using connection wire, clip, adapter, and so on.
1. Base/Gate terminal
Connect the terminal to the gate or base terminal of DUT.
2. Collector/Drain terminal
Connect the terminal to the drain or collector terminal of DUT.
3. Emitter/Source terminal
Connect Force and Sense to the source or emitter terminal of DUT.
4. AC/DC Guard terminal
When the CV LED lights, this terminal works as the AC guard.
When the IV LED lights, this terminal works as the DC guard.
In the most cases, never connect anything to this terminal for safety and to
prevent instrument damage.
5. Chassis common terminal
Use for grounding or shielding.
1- 14
Collector/Drain
Base/Gate
±3 kV
Max
Keysight B1507A User's Guide, Ed ition 1
Advertisement
Table of Contents
