Keysight Technologies B1507A User Manual page 125

Power device capacitance analyzer
Table of Contents

Advertisement

Collector/Drain
drive settings
Hold Time
Delay Time
Zero Bias Time
Specify the output settings for the collector-emitter or drain-source voltage. You can
set them up depending on the types of the selected measurement: forcing the
constant bias voltage or sweeping the bias voltage.
Collector/Drain Voltage Bias:
You can specify the following parameters to force the constant bias voltage.
Bias
Specify the bias voltage.
Setting range: 3000 V to +3000 V
Collector/Drain Voltage Sweep:
You can specify the following parameters to sweep the bias voltage.
Start
Specify the sweep start value.
Setting range: 3000 V to +3000 V
Stop
Specify the sweep stop value.
Setting range: 3000 V to +3000 V
Sweep Mode
Select one from the following sweep modes.
LinearSingle (Sweep from start to stop in a linear incremental step)
LogSingle (Sweep from start to stop in a logarithmic incremental step)
LinearDouble (Sweep from start to stop to start in a linear incremental step)
LogDouble (Sweep from start to stop to start in a logarithmic incremental
step)
Number of Step
Specify the number of sweep steps from start to stop.
Setting range: 1 to 1001
Hold Time
Keysight B1507A User's Guide, Ed ition 1
Capacitance Measurement Software
GUI Reference
4- 17

Advertisement

Table of Contents
loading

Table of Contents