Table of Contents
Advertisement
How To Perform Measurement
How To Calculate Power Loss
For the drive conditions and the device parameters for power loss calculation that
extracted from the loaded measurement data, see "Measurement Data and Extracted
Drive Conditions and Device Parameters for Power Loss Calculation" on page 25".
You can confirm or change the drive conditions for power loss calculation by
clicking the Drive Conditions tab at the left of work area.
Also, you can confirm or change the device parameters for power loss calculation by
clicking the Device Parameters tab.
Step 5. Select a drive condition or device parameter to be swept and specify the sweep
condition.
If you select a drive condition parameter to be swept, click the Drive Condition tab
and mark the check box of the desired drive parameter.
If you select a device parameter to be swept, click the Device Parameters tab and
mark the check box of the desired device parameter.
This example select a switching frequency to be swept.
1. Click the Drive Conditions tab and mark the check box of the Switching
Frequency parameter to select.
2. Specify the sweep condition in the Value column.
Start
3- 22
Sweep start value
Keysight B1507A User's Guide, Ed ition 1
Advertisement
Table of Contents
