Table of Contents
Advertisement
Chapter 18 System Setting and Maintaining
4
156
a
Tap the drop-down list button for the Language.
Default setting is English.
b
Select a language option from the drop-down list.
Available languages may vary depending on the country or region where the instrument
is purchased.
–
Power On: Select the power-on option from the choices: Preset to boot up with factory
default settings and Last with the settings at the last power-off or shut-down of the
instrument.
–
Sound: To adjust the volume, tap the volume input box and then enter a number between 1
and 10 by using the numeric keys or the rotary knob. To turn off the Sound for the key
strokes and alarms, select Off.
–
Display Mode: Select the display mode option from the choices: Indoor, Outdoor, and
Night. The instrument adjusts its display background and chart color properties to best fit to
each selection.
–
Sleep/Hibernate: To set the amount of time for entering into power saving mode, complete
the following steps:
a
Tap the bar for the Sleep/Hibernate.
The pop-up window appears. Default setting is Hibernate with 40 minutes.
b
Touch the Sleep Time input box and then enter a number between 0 and 60.
The sleep mode turns off the display backlight to save power.
c
Touch the Hibernate input box and then enter a number between 0 and 60.
The hibernation mode puts the instrument into the standby mode to save power.
This setting is predominant over the sleep time setting.
d
Tap the Apply button.
–
Keypad Backlight: Select the keypad backlight option from the choices: Always On to
illuminate the backlight always, On for a few seconds, and Off to turn it off.
–
LCD Brightness: Touch the LCD Brightness input box and then enter a number between 1
and 10 by using the numeric keys or the rotary knob.
The larger you set the number, the brighter the display illuminates.
–
App Interface: To select your preferred application interface protocol to remotely control
your instrument for each connection method, complete the following steps:
a
Tap the bar for App Interface.
The pop-up window appears.
b
Select the LAN app interface option from the choices: App SW to use an application
like JDViewer or JDRemote, and SCPI to use SCPI commands.
c
Select the USB app interface option from the choices: App SW to use an application
like JDViewer or JDRemote, and TMC to use USB TMC protocols.
d
Select the UART app interface option from the choices: SCPI to use SCPI commands
and Other to use other application software via RS-232C.
e
Tap the Apply button.
–
Trace Location: To specify a new location to initially load trace data (*.tra) when using
JDViewer or other software, complete the following steps:
a
Tap the bar for the Trace Location.
The Trace Location window appears.
b
Highlight a folder or location other than the default /Internal.
c
Tap the Apply button.
Tap the Apply button in the lower-right corner of the screen to save the change(s) and return to
the measurement screen.
CellAdvisor JD720C User's Manual
Advertisement
Table of Contents
